Does Concrete Keep Getting Stronger Over Time?

Does concrete keep gaining strength after it cures? In this article, concrete aging means the change in strength as concrete gets older. For concrete, the long-term claim is not verified, and the one long-term study read tested mortar.

Quick Answer

Early strength development relates to the rate of cement hydration, according to NRMCA CIP 39. The Concrete Strength Calculator starts from a 28-day strength. Whether concrete keeps gaining strength after 28 days is not verified. The one long-term study read tested mortar, and its water-stored samples were somewhat weaker at 5 and 10 years than at 1 year.

Why 28 Days Is the Reference Age

The 28-day strength is the input the Concrete Strength Calculator starts from, and it estimates other ages from that value. The reason 28 days was chosen is not verified here, because no ACI or PCA text was readable for this article.

Treat 28 days as a reference point, not a finish line. The sources read here do not say concrete reaches its full strength at 28 days.

What the Sources Say About Concrete Aging

Three sources were read for this article. As read here, none of them gives a percent gain for concrete after 28 days.

Three sources read for this article and what each says
Source Material studied Ages covered What it says about strength after 28 days
NBS Building Science Series 8, Part 1 Mortar cubes, 199 cements 24 hours to 10 years Water-stored averages rose through 1 year, then were somewhat lower at 5 and 10 years.
NRMCA CIP 39, maturity methods Concrete, maturity estimates Not stated in the text read No 28-day or long-term figure. Says early strength development relates to cement hydration.
FHWA-HRT-06-004, pavement tech brief Concrete pavement maturity and curing Not stated in the text read Says high curing temperature may cut long-term strength. Gives no percent gain.

The NBS study is the only long-term source read. It tested mortar cubes, not concrete, so its results cannot be applied directly to a concrete slab or column.

What the Long-Term Mortar Study Found

For mortar, water-stored average strength rose through the 1-year tests, then was somewhat lower at 5 and 10 years. Read this as a mortar result, not a concrete one.

  • Setup. The study used mortar cubes made with a 1:2.75 mix of cement to graded Ottawa sand. It covered 199 cements, tested at ages from 24 hours to 10 years.
  • Water versus moist air. 154 of the 199 cements had lower strength after 1 year in water than after 1 year in moist air.
  • Limits. The text was read from an OCR scan and is partly garbled. The publication year is not verified. The sources read here do not explain the water-storage result.

How Curing Temperature Changes the Picture

High curing temperature may raise early strength while lowering later strength, according to an FHWA technical brief. The brief says concrete cured at high temperatures “may develop higher early-age strength but reduced long-term strength.”

The same brief says the long-term effects of early-age temperature may not be fully characterized. CIP 39 ties early strength to hydration, so a simple rule that more heat always adds strength does not hold up in these sources.

Direction of curing temperature effects Qualitative sketch, not to scale. At early age, the bar for high-temperature curing is taller than the bar for lower-temperature curing. At long-term age, the bar for high-temperature curing is shorter than the bar for lower-temperature curing. The shape follows the FHWA brief’s wording. The brief gives no numbers for this trade-off. Direction of effect by curing temperature Lower-temperature curing High-temperature curing Early age Long-term age Qualitative direction only, based on the FHWA wording. Not to scale.
Direction only, from the FHWA wording. The brief gives no numbers for this trade-off.

Using the Calculator Curve for Planning

The Concrete Strength Calculator estimates strength at other ages from a 28-day value. Its curve is model output and is not checked against an ACI text. Here is the page’s example, hand-checked.

  1. Set the inputs. Use 4,000 psi at 28 days, 7 days of age, and moist-cured Type I cement. The page’s answer is 2,814 psi.
  2. Work the formula. Strength equals 28-day strength x age / (4.0 + 0.85 x age). At 7 days, 4,000 x 7 = 28,000, and 4.0 + 0.85 x 7 = 9.95.
  3. Divide. 28,000 / 9.95 = 2,814.1 psi, which matches the page. That is about 70.4 percent of 4,000 psi.
  4. Check the other ages. At 3 days, 12,000 / 6.55 = 1,832.1 psi. At 14 days, 56,000 / 15.9 = 3,522.0 psi. Both match the page.
  5. Check 28 days. 4,000 x 28 / 27.8 = 4,028.8 psi, or 100.7 percent. The formula does not land exactly on 100 percent, so read it as a model value.
Tool example: estimated strength by age A line rising from zero at 0 days through estimated strengths of 1,832 psi at 3 days, 2,814 psi at 7 days, 3,522 psi at 14 days and 4,029 psi at 28 days. A dashed line marks the 4,000 psi input. The gains between points get smaller, and the curve sits slightly above the input at 28 days. This is the calculator’s model curve, not verified against ACI 209 text. Tool example: 4,000 psi concrete, estimated strength by age 4,000 psi input 1,832 2,814 3,522 4,029 3 days 7 days 14 days 28 days Model output from the calculator, moist-cured Type I. Not checked against ACI 209 text.
The calculator’s model curve. Gains between points get smaller, and the value at 28 days is 100.7 percent of the input.

For a measured result, use test cylinders. The concrete cylinder test guide explains how samples are taken and broken. Cover depth is a separate topic, and the rebar concrete cover guide covers it.

Run your own age and strength

Enter your own 28-day value and age to see an estimate. Then compare it with a cylinder test before you rely on it. Try your own numbers in the strength calculator.

FAQs About Concrete Strength Over Time

What does concrete aging mean?

In this article, concrete aging means the change in strength as concrete gets older. The FHWA brief ties strength to age and temperature history, but no source read here verifies a long-term gain for concrete.

Does concrete reach full strength at 28 days?

No source read here says concrete reaches full strength at 28 days. The 28-day value is the reference the calculator starts from, and the reason for that age is not verified.

Did the NBS study test concrete?

No. It tested mortar cubes made with cement and graded Ottawa sand, at ages from 24 hours to 10 years. Its findings should not be read as concrete data.

Does water curing make concrete stronger over time?

Not verified for concrete. In the NBS mortar study, 154 of the 199 cements had lower strength after 1 year in water than in moist air.

Does hot curing make concrete stronger?

It may raise early-age strength, but it may also lower long-term strength, according to an FHWA brief. The brief adds that these long-term effects may not be fully characterized.

Can the calculator estimate strength at 14 days?

Yes, as an estimate. For 4,000 psi at 28 days, the calculator’s curve gives about 3,522 psi at 14 days. That is model output, so use cylinder tests for a measured value.

Is the calculator’s 28-day value exactly 100 percent?

No. The calculator’s formula gives about 100.7 percent at 28 days, because it is not normalized to the input at that age. Treat the small difference as model output.

Sources and Further Reading

References Used in This Article

The long-term strength statements here come from a mortar study and a pavement brief, not concrete long-term data. The calculator’s curve is not checked against an ACI text. Reviewed for accuracy by Prof. Dr. Khalil Mudassar, PhD. Last updated 2026-11-11.